WLED Setup

●Stable

WLED is open-source firmware for addressable LEDs. Hyphi devices ship with WLED pre-flashed. This guide covers first-time setup and network configuration.

First Boot

1. Power on the device
2. WLED creates a Wi-Fi access point: WLED-AP (password: wled1234)
3. Connect to WLED-AP from your phone or laptop
4. Browser opens automatically to 4.3.2.1 — if not, navigate there manually
5. You're in the WLED UI

Connect to Your Wi-Fi

1. WLED UI → Config → WiFi Setup
2. Enter your network SSID and password
3. Click Save & Connect
4. Device reboots and joins your network
5. Find the IP via your router's DHCP table, or use the WLED app (iOS/Android)

mDNS

WLED supports mDNS. On most networks you can reach the device at http://wled-XXXXXX.local where XXXXXX is the last 6 chars of the MAC address.

WLED App

The official WLED app (iOS / Android) handles device discovery automatically on your local network:

• iOS: WLED on App Store
• Android: WLED on Play Store

Initial LED Config

Before using effects, set the correct LED count for your device:

→ See WLED Custom Config for the full LED preferences walkthrough.

Troubleshooting

Symptom	Fix
WLED-AP not appearing	Hold BOOT button 5s to reset Wi-Fi config
LEDs all wrong color	Check RGB order setting (GRB is most common for WS2812B)
LEDs flickering	Check power supply, add decoupling cap — see Current Limit
Can't reach 4.3.2.1	Disable mobile data, connect only to WLED-AP